IntelliSet
Select a preset product profile using IntelliSet
IntelliSet lets you select a pre-programmed product profile by name. Each profile automatically sets the correct operating mode, setpoint, defrost interval, and other settings for that product. For example: • APPLES — Continuous operation at 35°F (1.7°C), defrost every 3 hours • CHEESE — Continuous operation with setpoint range of 35°F to 42°F (1.7°C to 5.6°C) • ICE CREAM — Start-Stop operation at -22°F (-30°C), defrost every 12 hours
The above are examples of possible settings. Factory IntelliSets are available from your authorized Carrier Transicold Truck/Trailer dealer.
An IntelliSet may be pre-programmed as "IntelliSleep," which allows Sleep mode to be entered by simply changing to that IntelliSet.
Range Protect may be applied to any IntelliSet. It prevents freezing or overheating of non-sensitive cargo by locking the unit in Start-Stop Operation when the compartment temperature is within the preset range (default 35 to 70°F / 1.6 to 21.1°C). Range Protect offers increased fuel savings over normal Start-Stop Operation.
Selecting an IntelliSet
With the unit powered up (START/RUN-OFF switch in START/RUN) and the default screen displayed, press the EQUALS (=) key. If the IntelliSet screen appears, proceed to Step 3. Otherwise, proceed to Step 2.
Press the MENU key until INTELLISET is displayed. Then press the INTELLISET soft key to display the IntelliSet screen.
The IntelliSet screen displays with a 10-second timeout and shows five of the available IntelliSets. The currently active IntelliSet will show "Active" or "Modified" to the right. The total number of available IntelliSets is shown in parentheses on the first line.
Press the UP (▲) or DOWN (▼) key to scroll through the list. Highlight the desired IntelliSet and press the EQUALS (=) key. The selected IntelliSet becomes active and an "INTELLISET CHANGED" message will display.
Press the EXIT soft key to return to the default display.
If setpoint change is allowed within the selected IntelliSet, refer to the Changing Setpoint page for instructions.
To go directly to the IntelliSet screen when pressing the EQUALS (=) key, set "ENABLE INTELLISET AT = KEY" to "YES" in the Configuration settings (Section 5.2.3).