IntelliSet
Select a preset product profile using IntelliSet
IntelliSet allows you to select a pre-programmed product name (e.g. "APPLES", "CHEESE", "ICE CREAM") and the APX Control System automatically applies the correct settings for that product — including operation mode, setpoint, and defrost interval. This provides the best temperature control, fuel economy, and performance for each load.
Over 40 different products can be pre-programmed with settings such as: • Operation mode (Continuous or Start-Stop) • Temperature setpoint or setpoint range • Defrost interval Settings can be locked so they cannot be changed. If a setpoint range is locked, you can still adjust the setpoint within that range.
Factory IntelliSets are available from your authorized Carrier Transicold Truck/Trailer dealer.
IntelliSet may be pre-programmed as "IntelliSleep", which allows Sleep mode to be entered by simply changing to that IntelliSet.
Range Protect can be applied to any IntelliSet. It prevents freezing or overheating of non-sensitive cargo by locking the unit in Start-Stop Operation when the compartment temperature is within the preset range (default 35 to 70°F / 1.6 to 21.1°C). Range Protect offers increased fuel savings over normal Start-Stop Operation.
Selecting an IntelliSet
With the system powered up (START/RUN-OFF switch in START/RUN) and the default screen displayed, press the "=" key. If the IntelliSet screen appears, proceed to Step 3. Otherwise, proceed to Step 2.
Press the MENU key until INTELLISET is displayed. Then press the INTELLISET soft key to display the IntelliSet screen.
The IntelliSet screen displays with a 10-second timeout and shows five of the available IntelliSets. The currently active IntelliSet will show "Active" or "Modified" to the right. The total number of available IntelliSets is shown in parentheses on the first line.
Press the ▲ or ▼ key to scroll through the list. Highlight the desired IntelliSet and press the "=" key. The highlighted IntelliSet becomes active and an "INTELLISET CHANGED" message will display.
Press the EXIT soft key to return to the default display.
If setpoint change is allowed for the selected IntelliSet, refer to the Changing Setpoint page for instructions.
If "ENABLE INTELLISET AT = KEY" is configured to "YES", pressing the "=" key from the default screen will go directly to the IntelliSet screen.