Technician Test Required
engine
Description
Low Oil Pressure, High Coolant Temp, Coolant Temp Sensor, or Starter Output Fault occurred 3 times within the last 2 hours of engine running time, and the unit shuts down.
Activation Conditions
Alarms 11 (Low Oil Pressure) or 12 (High Coolant Temp) or 126 (Coolant Temp Sensor) or 2006 (Starter Output Fault) individually occur three times within the last two hours of engine running time. This alarm is enabled by configuring Coolant Sensor Alarm Shutdown or High Engine Temp Shutdown or Engine Oil Press Shutdown to YES. The timer values and counters for number of times for alarm will be kept across power cycle. The time remaining on the timer will be stored in the NVD memory. This alarm cannot be cleared from the active queue. If this alarm is activated, both this alarm and the ala.rm that caused it will remain in the active alarm queue after power cycle
Unit Behavior
Required Shutdown
Reset Conditions
Alarm reset from CabinTech
Corrective Actions
1. Determine Which Alarm Activated This Alarm: Check active alarm list for 00011 Check Engine Oil Pressure, 00012 High Coolant Temperature, 00126 Check Engine Coolant Sensor, or 02006 Starter Output Fault. One of these alarms will be present. Follow the troubleshooting steps for the alarm(s) found and correct the alarm condition. All alarm conditions must be corrected. 2. Reset Alarm: Clear all inactive alarms (Section 5.2.2). All alarms must be cleared to start unit.